Lime Wash Prep-Coat
As low as $35.00
Fast to apply, matt white preparation paint specially formulated to create the ideal base coat for Bauwerk Limewash and for all common interior surfaces for new and renovation projects.
Limewash Prep-Coat is suitable for previously painted walls, where a fresh new surface is desirable. Gypsum and lime plasters, Gyprock and all repaired surfaces should first be prepared with a deep penetrating primer-sealer to prevent "ghosting". Ghosting is caused by the difference in absorbency between the drywall / Gyprock panel and the filler material for the joints and fixing points or any repaired areas.
For the above mentioned reasons most decorators prepare the surface and apply a good quality water based acrylic SEALER (minimum 2 coats, or until surface has equal absorbency) that will prevent any “ghosting” from a local manufacturer and follow their application instructions.
Colour Advice: Our Limewash Prep-Coat allows for really deep and intense colours, please be advised that some colours painted on top of the Prep-Coat may appear slightly more saturated when compared to Colour Cards.
We always recommend the use of sample pots of lime wash paint on top of the Prep-Coat for an accurate colour representation and consumption for your particular surface and light conditions.
Not required for interior surfaces such as render brick and natural absorbent surfaces.
- very low VOC content (<1 gr/lit)
- water-dilutable, low odor
- free from mould causing substances
- emission-minimized and solvent-free
- opaque matt white finish
- easy workability
Note: Prep-Coat is only suitable for interior use
Approximately 0,15 lit/m2 per coat on a smooth substrate; on rough surfaces correspondingly more.
Approximately 6 m2/lit (approximately 60sqft/lit) per coat on a smooth substrate; on rough surfaces correspondingly more.
Values for coverage are to be used as a guide only, variation in quantity needed will depend on the porosity of the surface to be painted.
Limewash Prep-Coat can be sprayed, rolled or brushed on. 1 coat is usually adequate, a second coat can be applied if required. The surface should have equal suction or been prepared to have equal suction to prevent "ghosting" if a regular finish is desired.
At +20°C (+68°F) and 65% rel. Surface dry and re-coatable after 3 – 4 hours. At lower temperatures and higher humidity, these times are longer.
The paint is ready to use and only needs to be stirred well. It can be painted, rolled or sprayed. First paint the ceiling, then the walls. To avoid visible lines, start at the window and brush away from the light.
On walls with patching, stark colour variations or other inconsistencies we recommend to apply two coats of Limewash Prep-Coat. The first coat can be diluted with up to 10% clean water. Apply the last coat always undiluted.
Apply the paint evenly in varying directions, working wet on wet, in a single application.
Clean working tools with water after use.
Do not use below +5°C (+41°F)